Posted 2 years ago
princehenr…
(2 items)
Scottvez,
Here are some more pics of the pistol. Upon further inspection of the pistol, I found a flaw that concerns me. When I pulled the hammer back, the cylinder did not rotate. I don't know how much it would cost to fix. What would that do to the value of the pistol? As far as your question, yes I would be interested if the value was not depreciated too far for the defect. Let me know what you think.
Thanks again,
Dave
The Killer Mobile Device for Victorian Women
If These Shirts Could Talk: The Tantalizing Tales Behind Used Clothes
Gloriously Grotesque 19th-Century Pipes
In the Hot Seat: Is Your Antique Windsor a Fake?
Bizarro Beauty Products, from 1889 to Now
Love at First Kite: How Pizza and Pente Led to One Oklahoman's High-Flying Obsession
Pin-Up Queens: Three Female Artists Who Shaped the American Dream Girl
Say Ahhh: An Oral Surgeon's Quest to Reimagine the Garage-Band Guitar
Tokens for Sweethearts, in Times of War
American Picker Dream, Part I: Mike Wolfe On His Love Affair With Bikes




The most common reason for the cylinder not to rotate when the hammer is cocked is a broken hand-spring. It's not a terribly expensive repair, but it will slightly lower the value of the gun.
I have been a gunsmith for over 40 years. A hand spring does not have a serial number therefore a replacement is not goeing to lower value, it is commen for flat springs to break.
Agree with Gundoc-- ONCE the repair has been conducted, it shouldn't hurt the value.
Unrepaired it does lower the value.