Share your favorites on Show & Tell

Unusual Gage? Tool?

In Tools and Hardware > Show & Tell.
Unsolved mystery items3774 of 87728Art paintings Antique mall find-Slag glass lamp
6
Love it
0
Like it

officialfuelofficialfuel loves this.
BrunswickBrunswick loves this.
kwqdkwqd loves this.
fhrjr2fhrjr2 loves this.
fortapachefortapache loves this.
bobby725bobby725 loves this.
See 4 more
Add to collection

    Please create an account, or Log in here

    If you don't have an account, create one here.


    Create a Show & TellReport as inappropriate


    Posted 11 months ago

    lptools
    (25 items)

    Hello, I am not sure what these are. All are stamped "left hand thread" ( which I believe is the coarse thread showing). On the left end is an 1/8" diameter spline shaft. The right ends have knurling parallel to the length of the tool. The nut on the left end unscrews, but has given me no clue. Turning the the small knurled piece on the right end in an arc ,turns the splined shaft in an arc ( does not rotate) . Overall length is approx. 7" They are also stamped 0-20, 0-50, 0-200 and 0-300. Thanks for any help, Lou

    Unsolved Mystery

    Help us close this case. Add your knowledge below.

    logo
    Tools and Hardware
    See all
    Lie-Nielsen No. 62 Low Angle Jack Plane Set With 4 Blades
    Lie-Nielsen No. 62 Low Angle Jack P...
    $251
    Rectangular Cast Iron Floor Register Heat Grate Antique Replica Louvered Heating
    Rectangular Cast Iron Floor Registe...
    $109
    STANLEY BAILEY No.7 JOINTER PLANE
    STANLEY BAILEY No.7 JOINTER PLANE...
    $130
    RARE HUGE Antique Iron & Brass Mickey Ear Shaped Padlock Hardware Lock & Key NR
    RARE HUGE Antique Iron & Brass Mick...
    $113
    logo
    Lie-Nielsen No. 62 Low Angle Jack Plane Set With 4 Blades
    Lie-Nielsen No. 62 Low Angle Jack P...
    $251
    See all

    Comments

    1. fhrjr2 fhrjr2, 11 months ago
      They appear to be specialty go - no go tools that would be used by quality control to insure the item is within specs.
    2. lptools, 11 months ago
      Hello, fhrjr2. Thanks for the reply.I brought these in to work, still no definite answer. All of the small spline ends are the same diameter .108. The shafts that go through the body are different diameters, and offer a different level of resistance when you rotate the knob on the right end. Also noticed were the differences in the size of the end fittings , corresponding increase in diameter in relation to the ranges that are stamped on the body. The third photo in the original post shows the differences in the ends. If you look closely at the 4th photo, ( squinting may be required) you may see the difference in the shaft diameters.

    Want to post a comment?

    Create an account or login in order to post a comment.